Installation instructions (except Presta Valves) 

1. Shake bottle well. 
2. Turn wheel valve to either 4 or 8 o'clock position. 
3. Remove inner valve from tyre with supplied valve spanner. 
4. Cut off valve spanner where serration meets smooth area. 
5. Place nozzle over valve stem and insert correct amount of SLUDGE TYRE SEALANT. 
6. For valves difficult to reach, use a 8 mm tube. 
7. If blockage of valve stem does occur do not force but use a thin wire or paper clip to clear blockage. 
8. Remove bottle - grease inner valve before replacing. 
9. Reinflate tyre to correct pressure. 

Note: An air source is required to reinflate tyre after installation. 

Installation instructions (Presta Valves) 

1. Shake bottle well. 
2. Turn wheel valve to either 4 or 8 o'clock position. 
3. Unscrew inner valve all the way open an let all air out. 
4. Cut tip of nozzle off as indicated on box. 
5. Turn bottle nozzle over valve to cut thread in nozzle. 
6. Squeeze 50ml of SLUDGE liquid into tube or tyre. 
7. Grease inner valve with petroleum jelly before inflating. 
8. Inflate tube or tyre and keep inflated to manufacturers specifications. 

Note: An air source is required to reinflate tyre after installation

Wheel Balance

If tyres are in balance before installing SLUDGE TYRE SEALANT, it will not effect the wheel balance. It is not possible to re-balance tyres with SLUDGE still inside the tyres. The reason for this is that SLUDGE is a liquid and this confuses the balancing machine which then gives an incorrect reading while the tyre is in fact still perfectly in balance. These tests have been done by various reputable tyre specialists and can be relied on.

Quantities required per wheel:

• Road Racing Bicycle(Presta Valve) - 50 ml per wheel 

• Mountain Bicycle - 100ml per wheel 

• Motorbike - 200ml per wheel 

• Motorcars - 200ml to 300ml per wheel 

• Pick-up & 4x4 - 400ml per wheel 

• Truck - 1000ml per wheel 

N.B. Balance wheels BEFORE adding SLUDGE.

<<< PREVIOUS     NEXT >>>